Avaya Configuring IP Utilities Bedienungsanleitung PDF herunterladen (Seite 65)

114071 Rev. A 6-1

Chapter 6

Customizing NTP Services

This chapter describes how to create and customize NTP services. You should

have read Conﬁguring Routers or Conﬁguring Customer Access and Trunks (BNX

Software), as appropriate for your platform, and have performed the following

tasks:

1. Opened a conﬁguration ﬁle in local or remote mode

1. Selected the appropriate router type, speciﬁed a slot, and selected the link

or net module that you want to insert in the slot (if you are using a local

mode conﬁguration ﬁle)

2. Conﬁgured IP on an interface using the default parameters, as described

in Chapter 1

3. Veriﬁed that the time servers that you want to conﬁgure on the network

are reachable via IP

To do this, you must ping the IP address of the time server you want to

conﬁgure. If the server you want to conﬁgure is not on the local network, you

will need to conﬁgure the appropriate IP routing protocol, such as RIP or

OSPF. For information on pinging a server or conﬁguring routing protocols,

refer to Conﬁguring IP Services.

4. Created NTP in the Conﬁguration Manager window

You can create and enable NTP easily by using all the default parameter values

that the Conﬁguration Manager supplies.

If you decide to change some or all of the default parameters, refer to the

instructions in this chapter. For a list of NTP parameters, see Appendix B.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 95 96

Keine Kommentare

Avaya Configuring IP Utilities Bedienungsanleitung Seite 65