Avaya Connecting ASN Routers to a Network Bedienungsanleitung PDF herunterladen (Seite 65)

Configuring Network Booting

308652-14.00 Rev 00

3-15

Setting Up Routing Paths

You set up the routing path between a BOOTP server and a booting routers by

• Enabling BOOTP relay interfaces on all routers between the server and the

booting router

• Creating a BOOTP Relay Agent Forwarding Table for each router in the path

• Creating a BOOTP Client Interface Table for the upstream router when the

booting router is on a Frame Relay PVC in group access mode

Enabling Relay Interfaces

You must enable BOOTP relay (also called BOOTP pass-through or gateway) on

all interfaces in the paths between the booting routers and the BOOTP server.

Figure 3-1 shows an example of a network with BOOTP gateways.

Note:

If you are booting over an Ethernet LAN and the Site Manager

workstation is directly cabled to the LAN, you do not need to configure a

BOOTP routing path.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 107 108

Keine Kommentare

Avaya Connecting ASN Routers to a Network Bedienungsanleitung Seite 65