Avaya Using Technician Interface Software Bedienungsanleitung PDF herunterladen (Seite 292)

Using Technician Interface Software

C-4

308657-14.00 Rev 00

Remote Hosts and Filters

You use a management workstation to monitor event messages generated by

specific software entities on each router in your network. To receive event

messages from a router at your management workstation, you must

• Enable Syslog on the router

• Define in the Syslog host table any remote hosts you want to receive messages

• Configure entity-specific message filters for each host

You can configure entity filters using the Configuration Manager tool under Site

Manager, or with

set

and

commit

commands you enter at the Technician Interface

of the router.

Each entity filter selects only event messages that

• Originate from a router software entity that you specify by entity number

• Have an event message number or severity level that matches one of the

values you configured

• Originate from a router slot you specify

Figure C-2

illustrates how an entity filter limits the number of event messages

forwarded by Syslog from a router to a specific remote host. Each filter attribute

or parameter that you specify increases the selectivity of a filter.

Note:

This appendix covers Syslog configuration via Technician Interface

commands only. (For information about how to configure Syslog through Site

Manager, see Configuring and Managing Routers with Site Manager.)

1 2 ... 287 288 289 290 291 292 293 294 295 296 297 ... 343 344

Keine Kommentare

Avaya Using Technician Interface Software Bedienungsanleitung Seite 292