Avaya R2MFC Konfigurationsanleitung PDF herunterladen (Seite 45)

Chapter 4 Configuring the R2MFC MBM 45

R2MFC Media Bay Module Installation and Configuration Guide

Configuring the MFCR2 (external) link

The MFCR2 (external) link is configured directly on the R2MFC MBM by setting DIP switches,

and using a CLI on the R2MFC MBM. Standard predefined configurations already exist, and must

be used, whenever possible. Country code configurations set, by DIP switches, are hard-coded,

and can be changed only by using the CLI. See “Setting Config DIP switches” for a description of

how to set the predefined country code and second dial tone settings. The CLI can be used to

create a customized country codes. See “Creating a customized country code” on page 46 for a

procedure on how to create the customized country code.

Setting Config DIP switches

The Config DIP switch settings include diagnostic mode, country codes, and second dial tone.

Country codes include the default settings for the connection (link) for the country selected. See

Appendix A, “Config DIP switch settings and definitions,” on page 85 for the country code DIP

switch settings and their specifications.

Perform the following steps to set the Config DIP switches:

1 Power down the BCM.

2 Set the Config DIP switches to the appropriate country code and second dial tone setting that

coincides with your location.

See Appendix A, “Config DIP switch settings and definitions,” on page 85 for predefined

country code DIP switch settings and their specifications.

See “Turning on second dial tone” on page 52 for the procedure to turn on second dial tone.

The Config DIP switch settings are divided into the following parts:

• country or diagnostics - DIP switch 1

• country code - DIP switches 2 through 5

• second dial tone (on/off) - DIP switch 6

Figure 15 on page 46 shows the Config DIP switch layout.

Caution: Country configuration is read by the firmware upon power up or

restart. Changing the country, while the R2MFC MBM is operating, causes the

firmware to restart automatically after a delay of five seconds from the last DIP

switch change. All active calls during the restart are dropped.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 105 106

Keine Kommentare

Avaya R2MFC Konfigurationsanleitung Seite 45