Avaya R2MFC Konfigurationsanleitung PDF herunterladen (Seite 47)

Chapter 4 Configuring the R2MFC MBM 47

R2MFC Media Bay Module Installation and Configuration Guide

The custom profile remains in EEPROM, even if different country codes are selected with

the DIP switches, and is available again when the “custom profile” DIP switch setting is

selected. The first configuration change by the CLI overwrites the existing custom profile

as described above.

4 Set the Config DIP switches to custom profile. The new custom profile is used upon restart.

See Figure 16 for the custom profile DIP switch setting.

Figure 16 Custom profile DIP switch setting

PRI side (Internal Link) configurable parameters

The R2MFC MBM is recognized by the BCM as a Euro-ISDN PRI line. The configuration for the

PRI side (internal link) of the link is performed on the BCM through the Unified Manager. Refer

to the Installation and Maintenance guide for the host system for complete information on the

parameters that can be configured through the BCM. PRI side, internal link, and operational

parameters for E1framing and signaling are listed below:

E1 Framing

The list of E1 framing parameters are listed in Table 3.

Note: Only one custom profile exists in EEPROM, so the SaveCfg

command overwrites the previous custom profile saved to the EEPROM.

Table 3 E1 framing default parameters

Parameter Operational Value

Frame format alternate frame

PCM coding A-law

Common Channel Signaling TS16

123456

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 105 106

Keine Kommentare

Avaya R2MFC Konfigurationsanleitung Seite 47