Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Bedienungsanleitung PDF herunterladen (Seite 106)

104 Chapter 2 General CLI commands

212160-B

• “speed command,” next

• “default speed command” on page 105

• “duplex command” on page 105

• “default duplex command” on page 106

speed command

The speed command sets the speed of the port. The syntax for the speed

command is:

speed [port <portlist>] {10|100|1000|auto}

The speed command is in the config-if command mode.

Table 47 describes the parameters and variables for the

speed command.

Note: You cannot enable autonegotiation on fiber optic ports. You

cannot disable autonegotiation on the BPS2000 1-GT and BPS2000

2-GT MDA ports.

Table 47 speed command parameters and variables

Parameters and

variables

Description

port <portlist> Specifies the port numbers to configure the speed. Enter the port

numbers you want to configure.

Note: If you omit this parameter, the system uses the port number

you specified in the interface command.

10|100|1000|auto Sets speed to:

• 10—10 Mb/s

• 100—100 Mb/s

• 1000—1000 Mb/s or 1 GB/s

• auto—autonegotiation

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 232 233

Keine Kommentare

Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Bedienungsanleitung Seite 106