
186 Chapter 6 Policy-enabled networks and QoS
212160-B
Configuring COPS
You can enable COPS-PR, the dynamic management system, using the CLI. This
section covers:
• “qosagent server-control command,” next
• “show cops retry command” on page 187
• “show cops server command” on page 187
• “show cops stats command” on page 188
• “cops retry command” on page 191
• “cops server command” on page 191
• “default cops retry command” on page 192
• “no cops server command” on page 193
qosagent server-control command
The qosagent server-control command enables COPS. The syntax for the
qosagent server-control command is:
qosagent server-control {enable|disable} [retry-timer
<no-retry|1-86400>]
The qosagent server-control command is in the config mode.
Table 105 describes the parameters and variables for the
qosagent
server-control
command.
Table 105 qosagent server-control command parameters and variables
Parameters and variables Description
enable|disable Enables COPS.
retry-timer
<no-retry|1-86400>
Sets the value for the retry timer:
• no retry—connection retry not attempted after a failed attempt
• 1-86400—specifies the seconds between receipt of a connection
termination/rejection notification and initiation of a new connection
request
Kommentare zu diesen Handbüchern