Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Bedienungsanleitung PDF herunterladen (Seite 148)

146 Chapter 4 Spanning Tree, MLT, and Port-Mirroring

212160-B

The spanning-tree command by port sets Spanning Tree Protocol (STP) and

multiple spanning tree group (STG) participation for the ports within the specified

spanning tree group. The syntax for the

spanning-tree command by port is:

spanning-tree [port <portlist>] [stp <1-8>] [learning

{disable|normal|fast}] [cost <1-65535>] [priority <0-255>]

The spanning-tree command by port is in the config-if command mode.

Table 81 describes the parameters and variables for the

spanning-tree

command by port.

default spanning-tree command by port

The default spanning-tree command by port sets the spanning tree values

for the ports within the specified spanning tree group to the factory default

settings. The syntax for the

default spanning-tree command by port is:

default spanning-tree [port <portlist>] [stp <1-8>]

[learning] [cost] [priority]

Table 81 spanning-tree command by port parameters and variables

Parameters and

variables

Description

port <portlist> Enables spanning tree for the specified port or ports; enter port

or ports you want enabled for spanning tree.

Note: If you omit this parameter, the system uses the port

number you specified when you issued the

interface

command.

stp <1-8> Specifies the spanning tree group you want; enter the STG ID.

learning

{disable|normal|fast}

Specifies the STP learning mode:

• disable—disables FastLearn mode

• normal—changes to normal learning mode

• fast—enables FastLearn mode

cost <1-65535> Enter the path cost of the spanning tree; range is 1-.65535.

priority <0-255> Enter the priority value of the spanning tree; range is 0-255.

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 232 233

Keine Kommentare

Avaya Business Policy Switch 2000 Command Line Interface Release 2.0 Bedienungsanleitung Seite 148