
Chapter 3 Security 127
Reference for the Business Policy Switch 2000 Command Line Interface
The mac-security command for specific ports is in the config-if command
mode
Table 67 describes the parameters and variables for the
mac-security
command for specific ports.
mac-security mac-da-filter command
The mac-security mac-da-filter command allows you to filter packets
from up to 10 specified MAC DAs. You also use this command to delete such a
filter and then receive packets from the specified MAC DA. The syntax for the
mac-security mac-da-filter command is:
mac-security mac-da-filter {add|delete}<H.H.H.>
The mac-security mac-da-filter command is in the config command
mode.
Table 68 describes the parameters and variables for the
mac-security
mac-da-filter
command.
Table 67 mac-security command for a single port parameters and variables
Parameters and variables Description
port <portlist> Enter the port numbers.
disable|enable|learning Directs the specific port:
• disable—disables BaySecure on the specified port
and removes the port from the list of ports for which
MAC address learning is being performed
• enable—enables BaySecure on the specified port
and removes the port from the list of ports for which
MAC address learning is being performed
• learning—disables BaySecure on the specified port
and adds these port to the list of ports for which MAC
address learning is being performed
Kommentare zu diesen Handbüchern