Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Bedienungsanleitung PDF herunterladen (Seite 114)

114 Chapter 3 Security

212160-A

Table 60 describes the parameters and variables for the eapol command for

modifying parameters

Table 60 eapol command for modifying parameters and variables

Parameters and variables Description

port <portnum> Specifies the ports to configure for EAPOL; enter the port number you

want.

Note: If you omit this parameter, the system uses the port number

specified when you issued the

interface command.

init Re-initiates EAP authentication.

status

authorized|unauthorizedauto

Specifies the EAP status of the port:

• authorized—port is always authorized

• unauthorized—port is always unauthorized

• auto—port authorization status depends on the result of the EAP

authentication

traffic-control in-outIin Sets the level of traffic control:

• in-out—if EAP authentication fails, both ingressing and egressing

traffic are blocked

• in—if EAP authentication fails, only ingressing traffic is blocked

re-authentication

enable|disable

Enables or disables re-authentication.

re-authentication-interval

<num>

Enter the number of seconds you want between re-authentication

attempts; range is 1 to 65535.

re-authenticate Specifies an immediate re-authentication.

quiet-interval <num> Enter the number of seconds you want between an authentication failure

and the start of a new authentication attempt; range is 1 to 65535.

transmit-interval <num> Specifies a waiting period for response from supplicant for EAP

Request/Identity packets. Enter the number of seconds you want to wait;

range is 1-65535.

supplicant-timeout <num> Specifies a waiting period for response from supplicant for all EAP

packets except EAP Request/Identity packets. Enter the number of

seconds you want to wait; range is 1-65535.

server-timeout <num> Specifies a waiting period for response from the server. Enter the number

of seconds you want to wait; range is 1-65535

max-request <num> Enter the number of times to retry sending packets to supplicant.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 199 200

Keine Kommentare

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Bedienungsanleitung Seite 114