Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Bedienungsanleitung PDF herunterladen (Seite 176)

176 Chapter 6 Policy-enabled networks and QoS

212160-A

qos ip-filter-set command

The qos ip-filter-set command adds or deletes currently defined IP filters

into an IP filter set. The syntax for the

qos ip-filter-set command is:

qos ip-filter-set <fgid> {create set <setid> [name

<setname>] filter <fid> filter-prec <prec>|delete}

The qos ip-filter-set command is in the config command mode.

Table 102 describes the parameters and variables for the

qos ip-filter-set

command.

Note: If you omit any parameter, the default value is used.

You cannot delete an IP filter that is referenced by an IP filter set.

Table 102 qos ip-filter-set command parameters and variables

Parameters

and variables

Description

<fgid> Enter an integer to specify the filter group ID; range is 1 to 65535.

create set

<setid>

Initiates creation of an IP filter set with the designated filter set ID.

Enter the IP filter set ID; range is 1 to 65535

name

Assigns a name to the designated filter set ID. Enter the name for the

filter set; maximum is 16 alphanumeric characters

filter <fid> Adds an IP filter to the filter set; range is 1 to 65535.

filter-prec

<prec>

Specifies the precedence, or filter evaluation order, within the set.

Enter the precedence value you want for this filter; range is 1 to

65535.

delete Deletes the IP filter set.

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 199 200

Keine Kommentare

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Bedienungsanleitung Seite 176