Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Bedienungsanleitung Seite 131

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 200
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 130
Chapter 4 Spanning Tree, MLT, and Port-Mirroring 131
Reference for the Business Policy Switch 2000 Command Line Interface
no spanning-tree command by port
The no spanning-tree command by port disables spanning tree for a port in a
specific spanning tree group. The syntax for the
no spanning-tree command
by port is:
no spanning-tree [port <portnum>] [stp <1-8>]
The no spanning-tree command by port is in the config-if command mode.
Table 73 describes the parameters and variables for the
no spanning-tree
command by port.
Table 72 default spanning-tree command by port parameters and variables
Parameters and
variables
Description
port <portnum> Enables spanning tree for the specified port or ports; enter port
or ports you want set to factory spanning tree default values.
Note: If you omit this parameter, the system uses the port
number you specified when you issued the interface
command.
stp <1-8> Specifies the spanning tree group you want to set to factory
default value; enter the STG ID. This command places the port
into the default STG.
Default value for STG is 1.
learning Sets the spanning tree learning mode to factory default value.
Default value for learning is normal mode.
cost Sets the path cost to factory default value.
Default value for path cost depends on the type of port.
priority Sets the priority to factory default value.
Default value for the priority is 0x8000.
Seitenansicht 130
1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 199 200

Kommentare zu diesen Handbüchern

Keine Kommentare