Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Bedienungsanleitung PDF herunterladen (Seite 46)

46 Chapter 1 CLI Basics

212160-A

Figure 6 show stack-info command output

renumber unit command

The renumber unit command changes the unit number of each switch in the

stack. The syntax for the

renumber unit command is:

renumber unit

The renumber unit command is in the config command mode.

The

renumber unit command has no parameters or variables.

Managing MAC address forwarding database table

This section shows you how to view the contents of the MAC address forwarding

database table, as well as setting the age-out time for the addresses. The following

topics are covered:

• “show mac-address-table command,” next

• “mac-address-table aging-time command” on page 48

• “default mac-address-table aging-time command” on page 49

Note: This command does not take effect until you reset the stack.

BPS2000#show stack-info

Unit # Switch Model MDA Model Cascade MDA SW Version

----------------------------------------------------------

1 BPS 2000 None None v1.2.0.01

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 199 200

Keine Kommentare

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Bedienungsanleitung Seite 46