Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Bedienungsanleitung PDF herunterladen (Seite 42)

42 Chapter 1 CLI Basics

212160-A

configure command

The configure command moves you to the Global Configuration (config)

command mode and identifies the source for the configuration commands. The

syntax for the

configure command is:

configure {terminal|network|memory}

The configure command is in the privExec command mode.

Table 4 describes the parameters and variables for the

configure command.

interface command

The interface command moves you to the Interface Configuration (config-if)

command mode. The syntax for the

interface command is:

interface FastEthernet {<port-num>|all}

The interface command is in the config command mode.

Note: You must have read-write access to the BPS 2000 switch to be

able to use the

enable command.

Table 4 configure command parameters and variables

Parameters and

variables

Description

terminal|network|

memory

Specifies the source for the configuration commands for the BPS 2000:

• terminal—allows you to enter config mode to enter configuration

commands

• network—allows you to set up parameters for auto-loading a script

at boot-up or for loading and executing a script immediately

• memory—not supported on BPS 2000

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 199 200

Keine Kommentare

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Bedienungsanleitung Seite 42