
BCC show Commands
308623-14.00 Rev 00
B-23
show fddi summary
The
show fddi summary
command displays the current configuration for all FDDI
circuits or a specific circuit or slot.
This command allows for the following command filters (flags) and filter arguments:
The output includes the following information:
-circuit
<circuit_name>
Displays information about the specified circuit only.
-slot
<slot>
Displays information about the specified slot only.
<circuit_name>
Displays information about the specified circuit only.
Slot/Conn Slot location of the FDDI module within the chassis and the
connector number.
Circuit Name of the circuit associated with this line.
Admin State Configured state of the FDDI interface: Up or Down.
HW Address Line’s physical address. The driver assigns this address.
Operational State State of the line driver: Down, Init (initializing), Not Present (enabled
but not yet started), or Up.
The Not Present state occurs for several reasons. For example, the
link module may not be physically present in the chassis; the
software may be booting and has not yet initialized the driver
software; the slot may be running diagnostics; or there may be a
problem with the configuration.
Total Time Up/Down If the line is not up (Operational State does not equal Up), then three
dashes (---) appear. If the line is up (Operational State equals Up),
then the value appears in the form:
hh
h
mm
m
ss
s
where
hh
is hours,
mm
is minutes, and
ss
is seconds. For example,
the value might appear as
5h31m05s
. If the value is greater than 24
hours, it appears in the form:
dd
d
hh
h
mm
m
where
dd
is days,
hh
is hours, and
mm
is minutes. For example, the
value might appear as
2d10h15m
.
(continued)
Kommentare zu diesen Handbüchern