Avaya R2 Installationsanleitung PDF herunterladen (Seite 136)

Installing a Wallboard

Chapter 5

Installing the Wallboard 5-3

Installing the Wallboard 5

To install an external wallboard to use with BCMS Vu software, complete the

following tasks:

• Unpack the wallboard.

• Be sure that a converter box that converts the communication protocol

from RS-485 (the wallboard protocol) to RS-232 (the PC protocol) is

included with the wallboard.

• Be sure that the wallboard installation document is included with the

wallboard.

• Connect the communications cable from the wallboard to the PC.

— If the serial port on the PC has 25 pins, use a DB25-to-RJ11

connection cable.

— If the serial port on the PC has 9 pins, use a DB9-to-RJ11 connection

cable.

For complete instructions on how to install Lucent wallboards, refer to the

manuals listed on the first page of this document.

For instructions on how to install other types of wallboards, refer to the

user’s manual that accompanies the wallboard.

Note

Lucent wallboards are addressed using hexadecimal

notation. You address them using the remote control unit

that comes with the wallboards. Refer to the user’s guide

that comes with the wallboard.

However, when you enter a wallboard address in the BCMS

Vu configuration procedure, you must use decimal notation.

Furthermore, BCMS Vu accepts wallboard addresses only

from 0 to 127 (decimal).

The table at the end of this chapter relates decimal addresses

from 0 to 127 to corresponding hexadecimal addresses.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 146 147

Keine Kommentare

Avaya R2 Installationsanleitung Seite 136