Avaya Configuring Routers Bedienungsanleitung PDF herunterladen (Seite 47)

Adding Network Interfaces

2-5

— If the connector requires a WAN circuit, the WAN Protocols window

appears (Figure 2-2).

Figure 2-2. WAN Protocols Window

Select the WAN protocol you want to enable on the circuit and click on

OK.

When you select a WAN protocol, note that

— Selecting Frame Relay, PPP, or SMDS automatically enables protocol

prioritization. For information on protocol prioritization, refer to

Conﬁguring Trafﬁc Filters and Protocol Prioritization.

— Once you select Standard, you cannot change the WAN protocol on this

circuit to any of the other protocols. If you later want to enable any other

protocol on this circuit, you must delete the circuit and start over. For

instructions on deleting a circuit from the router, refer to Chapter 4.

— When you enable a WAN protocol on the circuit, the synchronous line

parameters are automatically set, as Table 2-2 shows.

Table 2-2. Synchronous Line Parameters

Parameter Setting

BOLF Disable

Promiscuous Enable

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 103 104

Keine Kommentare

Avaya Configuring Routers Bedienungsanleitung Seite 47