Avaya Configuring Routers Bedienungsanleitung PDF herunterladen (Seite 58)

Configuring Routers

3-6

You replace an old conﬁguration ﬁle with the new one as follows:

1. Verify the integrity of the new ﬁle ﬁrst by booting with that ﬁle.

Refer to the section “Rebooting a Router with a Conﬁguration File” later in

this chapter.

2. Verify that there is enough space on the volume for another copy.

Select Tools➔Router Files Manager in the Bay Networks Site Manager

window.

The Router Files Manager window (Figure 3-3) displays the ﬁles, ﬁle sizes,

and available free space. The contiguous free space displayed in this window

applies only to memory cards.

3. Ensure that there is enough space on the volume for the ﬁle.

DOS Instructions: Ensure that the space occupied by the new ﬁle is not larger

than the available free space.

NVFS Instructions: Ensure that the space occupied by the new ﬁle is not

larger than the contiguous free space.

4. If enough space is available, copy the ﬁle to the old ﬁlename.

Refer to Managing Routers and BNX Platforms for detailed ﬁle management

instructions.

Saving a Conﬁguration File in Dynamic Mode

If you made changes to the currently active conﬁguration ﬁle in dynamic mode,

you can save these changes to a ﬁle on the router’s ﬁle system. This preserves the

current conﬁguration ﬁle, yet gives you the option to reboot the router with these

changes later. When you save these changes, the ﬁle is saved directly to the router.

To save your changes, start at the Conﬁguration Manager window and complete

the following steps:

1. Select File➔Save As.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 103 104

Keine Kommentare

Avaya Configuring Routers Bedienungsanleitung Seite 58