
Creating Line Pools
114062 Rev. A 7-45
Logical Lines Parameters
Use the following descriptions for configuring the ISDN logical lines parameters.
Parameter: Pool Channel Count
Default: Available B channels
Range: 1 to 2 (BRI)
| 1 to 23 (PRI – MCT1) | 1 to 30 (PRI – MCE1)
The channel count range for PRI depends on the number of B channels
you selected in the Timeslots window (refer to Figure
7-21) and the
number out of this total that you assign to each pool. For example, if you
have a total of 20 B channels and 5 of those channels are configured for
Pool 1, the range of this parameter for Pool 2 is 1 through 15 channels.
Five of the original 20 are not available because they are used by Pool 1.
Function: Determines the number of B channels in the line pool.
Instructions: Enter the number of B channels that you want in the line pool.
If you are configuring a multirate call, be sure that the value for this
parameter is not less than the maximum value that you can set for the
Aggregate Bandwidth parameter, which you configure when you set up an
outgoing phone list. For example, if the aggregate bandwidth is 256 Kb/s,
the value for this parameter should be 4.
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.8.11.1.5
Kommentare zu diesen Handbüchern