Avaya Configuring Dial Services Bedienungsanleitung Seite 89
- Seite / 326
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Dial Backup Implementation Notes
114062 Rev. A 5-5
When the router activates a line in the demand pool, the circuits in a demand
circuit group also become available. The router does not actually bring up the
circuits until it receives an incoming call. Demand circuit groups can only receive
calls.
A circuit group can belong to more than one demand pool. This enables the router
to use one configuration for circuits across the router’s slots. Note however, that
demand pools cannot cross slots.
Each demand circuit group has its own ID. This number is distinct from the
demand pool ID that identifies the line pool.
Note that both individual demand circuits and demand circuit groups can use the
same demand pool.
Caller Resolution for Demand Circuit Groups
Similar to individual demand circuits, demand circuit groups use either PAP or
CHAP to identify who is calling the router and to determine which circuit group
to activate. You can enable either of these authentication protocols on only one
side of the link (one-way authentication), or on both sides of the link (two-way
authentication). For information about authentication, refer to Chapter 3.
Depending on a network’s security requirements, each remote node can have a
unique CHAP Name or PAP ID, or the remote nodes can use the same name. For
each remote caller with a unique PAP ID or CHAP Name, the caller resolution
table contains a demand circuit group ID. The remote callers may use the same
demand circuit group ID. When it authenticates an incoming call, the recovery
router receives the ID or name, and then looks up the corresponding circuit group
ID in the table. From this circuit group, the router selects an available circuit and
establishes the unnumbered protocol configuration over that circuit.
To simplify configuration, the caller resolution table may contain the same PAP
ID or CHAP name for all remote nodes in the network. Then the table has only
one entry consisting of the name and the demand circuit group ID.
- Configuring Dial 1
- Services 1
- Bay Networks Software License 3
- Contents 5
- 114062 Rev. A vii 7
- 114062 Rev. A ix 9
- 114062 Rev. A 10
- 114062 Rev. A xi 11
- 114062 Rev. A xiii 13
- 114062 Rev. A xv 15
- 114062 Rev. A xvii 17
- About This Guide 19
- Audience 20
- Before You Begin 20
- Conventions 21
- Acronyms 22
- 114062 Rev. A xxiii 23
- 114062 Rev. A xxv 25
- Bay Networks Customer Service 26
- World Wide Web 27
- Customer Service FTP 27
- Support Source CD 28
- CompuServe 28
- InfoFACTS 29
- How to Get Help 29
- Chapter 1 31
- Dial Services Overview 31
- DS0005A 32
- Dial-on-Demand Service 33
- Demand Lines and Pools 34
- 192.32.14.0 35
- 192.32.16.0 35
- Activating Demand Circuits 36
- Terminating Demand Circuits 38
- Dial Backup Service 39
- Primary Line 40
- Backup Line 40
- 1-12 114062 Rev. A 42
- Backup Lines and Pools 43
- 1-14 114062 Rev. A 44
- Activating the Backup Line 45
- 1-16 114062 Rev. A 46
- Bandwidth-on-Demand Service 47
- 1-18 114062 Rev. A 48
- Activating Secondary Lines 50
- Terminating Secondary Lines 50
- Chapter 2 53
- ISDN Overview 53
- ISDN Standards 54
- Primary Rate Interface 55
- The D Channel 55
- 2-4 114062 Rev. A 56
- Figure 2-3. LAPD Frame 56
- ISDN Interfaces 57
- Reference Points 58
- 2-8 114062 Rev. A 60
- Chapter 3 61
- Implementation Notes 61
- Types of Authentication 62
- 114062 Rev. A 3-3 63
- 3-4 114062 Rev. A 64
- Asynchronous PPP 66
- ISDN Services 68
- 114062 Rev. A 3-9 69
- 3-10 114062 Rev. A 70
- 114062 Rev. A 3-11 71
- 3-12 114062 Rev. A 72
- 114062 Rev. A 3-13 73
- Call Screening 74
- Rate Adaption 74
- Example 1 75
- Example 2 75
- 3-16 114062 Rev. A 76
- Chapter 4 77
- PPP Multilink 78
- Static Routes 79
- Traffic Filters 80
- Dial Optimized Routing 81
- 4-6 114062 Rev. A 82
- Protocol Prioritization 83
- Chapter 5 85
- Bandwidth for Backup Circuits 86
- 114062 Rev. A 5-3 87
- 5-4 114062 Rev. A 88
- 114062 Rev. A 5-5 89
- 5-6 114062 Rev. A 90
- 114062 Rev. A 5-7 91
- 5-8 114062 Rev. A 92
- Chapter 6 93
- 6-2 114062 Rev. A 94
- 6-4 114062 Rev. A 96
- 114062 Rev. A 6-5 97
- Chapter 7 99
- Caution: 100
- Pool ID Parameter 107
- Configuring Dial Services 108
- Creating Line Pools 109
- Adding Line Pools 110
- Configuring ISDN Lines 115
- PRI Physical Interfaces 117
- 7-20 114062 Rev. A 118
- 7-22 114062 Rev. A 120
- 7-24 114062 Rev. A 122
- 123
- 124
- 126
- 128
- 129
- 7-32 114062 Rev. A 130
- 131
- 7-34 114062 Rev. A 132
- 137
- 7-40 114062 Rev. A 138
- 7-42 114062 Rev. A 140
- Configuring ISDN Logical Lines 141
- 7-44 114062 Rev. A 142
- 7-46 114062 Rev. A 144
- 114062 Rev. A 7-47 145
- 7-48 114062 Rev. A 146
- 7-50 114062 Rev. A 148
- Local Phone Number Parameters 149
- 7-52 114062 Rev. A 150
- 114062 Rev. A 7-53 151
- Changing Pool IDs and Lines 153
- 114062 Rev. A 7-57 155
- 7-58 114062 Rev. A 156
- 114062 Rev. A 7-59 157
- 7-60 114062 Rev. A 158
- 114062 Rev. A 7-63 161
- 114062 Rev. A 7-65 163
- Chapter 8 165
- Configuring Demand Circuits 165
- Interface for Dialup Lines 167
- Demand Circuit Parameters 169
- Configuring Demand Circuits 171
- 184
- Deleting Demand Circuits 186
- 114062 Rev. A 8-23 187
- 8-24 114062 Rev. A 188
- 4. Click on OK to save 188
- 8-26 114062 Rev. A 190
- 8-28 114062 Rev. A 192
- 114062 Rev. A 8-29 193
- Chapter 9 197
- Configuring Backup Circuits 197
- Circuit Options Parameters 202
- Configuring Backup Circuits 205
- Interface Type Parameter 211
- 219
- 219
- 220
- 9-26 114062 Rev. A 222
- 9-28 114062 Rev. A 224
- 227
- 228
- 228
- 9-34 114062 Rev. A 230
- 114062 Rev. A 9-35 231
- (Figure 232
- Deleting Backup Circuits 234
- Chapter 10 235
- Congestion Monitor Parameters 247
- Deleting Bandwidth Circuits 255
- Chapter 11 257
- Configuring Phone Lists 257
- Configuring Phone Lists 263
- Chapter 12 273
- Configuring Caller Resolution 273
- Configuring Caller Resolution 277
- Appendix A 281
- Configuration Examples 281
- Dial-on-Demand Using PPP 282
- Table A-3. IP Parameters 284
- A-4 114062 Rev. A 284
- Phone List window 285
- A-6 114062 Rev. A 286
- Configuration of Router 1 287
- Configuration of Router 2 288
- Configuration Examples 289
- Table A-10. Demand Pools 289
- A-10 114062 Rev. A 290
- Table A-14. IP Parameters 291
- A-12 114062 Rev. A 292
- A-16 114062 Rev. A 296
- Table A-23. IP Parameters 297
- A-20 114062 Rev. A 300
- Table A-26. Backup Pools 300
- A-22 114062 Rev. A 302
- Appendix B 305
- B-4 114062 Rev. A 308
- B-6 114062 Rev. A 310
- B-8 114062 Rev. A 312
- Appendix C 313
- Ordering PRI Lines 314
- 114062 Rev. A Index-1 315
- 114062 Rev. A Index-3 317
- 114062 Rev. A Index-5 319
- 114062 Rev. A Index-7 321
- 114062 Rev. A Index-9 323
- 114062 Rev. A Index-11 325
Verwandte Produkte und Handbücher für Software-Handbücher Avaya Configuring Dial Services
Software-Handbücher Avaya Business Communications Manager - LAN CTE Konfigurationsanleitung
(28 Seiten)
(28 Seiten)
Software-Handbücher Avaya DMC DECT Fundamentals - Communications Server 1000 Bedienungsanleitung
(340 Seiten)
(340 Seiten)
Software-Handbücher Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Bedienungsanleitung
(108 Seiten)
(108 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.030 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern