Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Bedienungsanleitung PDF herunterladen (Seite 50)

Configuring IP Exterior Gateway Protocols (BGP and EGP)

4-6

308628-14.00 Rev 00

• Destination-hash distribution based on the destination address only. IP

forwards all packets with a given destination address to the same next hop.

By default, in cases where IBGP uses the IP routing table to determine the next IP

hop to an IBGP peer, IBGP does not consider equal-cost multipath routes

submitted by RIP or OSPF. For more information about using ECMP for load

balancing, see Chapter 9, “Configuring Route and Traffic-Load Balancing

.”

By default, equal-cost multipath support is disabled on the router. You can use the

BCC or Site Manager to enable the feature and choose a distribution method.

Using the BCC

Navigate to the IP global prompt and enter:

ecmp-method

method

is one of the following:

disabled (default)

roundRobin

srcDestHash

destinationHash

Note:

To configure equal-cost multipath (ECMP) for BGP, you may also have

to configure ECMP for RIP, OSPF, or static routes.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 307 308

Keine Kommentare

Avaya Configuring IP Exterior Gateway Protocols (BGP and EGP) Bedienungsanleitung Seite 50