Avaya Configuring DECnet Services Bedienungsanleitung PDF herunterladen (Seite 49)

Editing DECnet Parameters

308619-14.00 Rev 00

3-11

DECnet Interface Parameter Descriptions

Use the following descriptions as a guide when you configure the parameters in

the DECnet IV Interface List window (refer to Figure 3-3

Parameter: Enable

Default: Enable

Options: Enable

Disable

Function: Enables or disables DECnet over this circuit.

Instructions: To disable DECnet over this circuit, set to Disable. Otherwise, accept the

default setting.

MIB Object ID: 1.3.6.1.4.1.18.3.5.2.2.1.2

Parameter: Route Level

Default: Level 1 and Level 2

Options: Level 1 and Level 2

Level 1 Only

Function: Determines whether the circuit performs both Level 1 and Level 2 routing

or Level 1 Only routing.

If you configured the router as Level 1 Only, the router automatically

configures all circuits as Level 1 Only and this parameter does not appear

in the DECnet IV Interface List window. If, at a later time, you change the

router configuration to perform both Level 1 and Level 2 routing, all

circuits will remain configured as Level 1 Only until you change them.

Instructions: Select Level 1 and Level 2 to maintain paths to all areas within a DECnet

network. Select Level 1 Only to maintain paths to only those systems

within the router’s local area.

MIB Object ID: 1.3.6.1.4.1.1.18.3.5.2.2.1.41

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 79 80

Keine Kommentare

Avaya Configuring DECnet Services Bedienungsanleitung Seite 49