Avaya Configuring DLSw Services Bedienungsanleitung PDF herunterladen (Seite 114)

Configuring DLSw Services

5-14

Following is a description of the parameters in the DLSw Interface Conﬁguration

window.

Parameter: Enable

Default: Enable

Options: Enable | Disable

Function: Enables or disables Data Link Switching over this interface.

Enable — Initializes the DLSw interface you added to a physical circuit.

Also use the Enable setting to reinitialize an existing DLSw interface

disabled earlier. The state of the interface depends on the up/down state of

the associated circuit and slot.

Disable — Switches a DLSw interface from the enabled (up) state to the

disabled (down) state.

Instructions: Select Enable if you previously set this parameter to Disable and now

want to re-enable Data Link Switching over this interface.

Select Disable only if you want to disable Data Link Switching over this

interface. This cancels all active LLC2 sessions currently supported by

the interface.

MIB Object ID: 1.3.6.1.4.1.18.3.5.1.5.2.1.2

Enabling a DLSw Interface Using the Edit Circuits Function

You can also access the Enable parameter of a DLSw interface through the Edit

Circuits function. To do so, begin at the Conﬁguration Manager window (refer to

Figure 5-1), and do either of the following:

• Select Circuits➔Edit Circuits to bring up the Circuit List window

(Figure 5-4); then select a circuit and click on Edit.

• Select a connector in the Conﬁguration Manager window to invoke the Edit

Connector window (Figure 5-5); then click on Edit Circuit.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 203 204

Keine Kommentare

Avaya Configuring DLSw Services Bedienungsanleitung Seite 114