Avaya Configuring MPOA Services Bedienungsanleitung PDF herunterladen (Seite 135)

Monitoring MPOA and NHRP Services

309249-14.00 Rev 00

C-15

show nhrp server configuration

The

show nhrp server configuration

command displays configuration

information about the NHRP server on the router. When you enter this

command,

the BCC displays the following information:

show nhrp server stats

The

show nhrp server stats

command displays statistical information about the

NHRP server on the router. When you enter this

command, the BCC displays the

following information:

State The configured state of this interface. A disabled interface cannot

be selected as the active interface for a circuit.

Type The type of VC that the NHRP client (NHC) will establish if no

encapsulation type has been specified for the virtual channel

identifier (VCI)

Forward Enable The configured state of NHRP server request forwarding (enabled or

disabled)

Link Protocol The type of layer 2 protocol (ATM)

Network Protocol The type of layer 3 protocol (IP)

NH Max Entries The maximum number of next-hop entries to keep. If the NH

Resolution Reply message contains a number of entries greater

than the specified maximum, the excess entries will be discarded.

NH Cache Size The maximum number of next-hop entries held in the cache

Pending Requests The maximum number of pending requests allowed for this NHRP

server

Server Enable The configured state of the NHRP server

Link Protocol The layer 2 protocol (ATM) associated with this server

Network Protocol The layer 3 protocol (IP) associated with this server

Resolve Request Rx The number of NHRP resolution requests received by this

server

Resolve Reply ACK Tx The number of positively acknowledged NHRP resolution

replies transmitted by this server

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 147 148

Keine Kommentare

Avaya Configuring MPOA Services Bedienungsanleitung Seite 135