Avaya Configuring MPOA Services Bedienungsanleitung PDF herunterladen (Seite 41)

Starting MPOA and NHRP Services

309249-14.00 Rev 00

2-11

Starting NHRP on an ATM PVC Service

To allow normally routed traffic to flow through an ATM PVC service and

between MPSs, enable IP plus an optional routing protocol (RIP or OSPF) on that

IP interface. (Configure RIP or OSPF if no routed paths exist between MPSs in

your ATM network).

To allow NHRP address resolution requests and replies to flow through the same

ATM PVC service and between MPSs, you must enable NHRP on that service.

You can use either the BCC or Site Manager to add IP, RIP or OSPF, and NHRP

to an ATM PVC service.

Using the BCC

To add IP, RIP or OSPF, and NHRP to an existing ATM PVC service:

Navigate to the appropriate pvc-service prompt and enter:

nhrp

Navigate back to the pvc-service prompt, and enter:

ip address

<IP_address>

mask

<subnet_mask>

At the resulting IP interface prompt, add a routing protocol (RIP or

OSPF):

rip

For example, on a System 5000 router, the following BCC commands navigate to

the pvc-service named “phoenix” and add NHRP, IP, and RIP:

stack#

atm/5/3/1

atm/5/3/1#

pvc-service servicename phoenix

pvc-service/phoenix#

nhrp

nhrp/phoenix#

back

ip/1.2.3.6/255.0.0.0#

rip

rip/1.2.3.6#

When you add NHRP to any ATM PVC service, the BCC automatically creates

the global NHRP object at root level if you have not already done so.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 147 148

Keine Kommentare

Avaya Configuring MPOA Services Bedienungsanleitung Seite 41