Avaya Configuring MPOA Services Bedienungsanleitung PDF herunterladen (Seite 60)

Configuring MPOA and NHRP Services

3-14

305861-A Rev 00

Configuring a Unique Selector Byte for an MPS Address

If you disable ATM address autogeneration, a newly created MPS uses the control

ATM address user suffix that you configured in the MPOA service record.

However, to ensure uniqueness among all ATM addresses used on the router, you

must additionally specify a unique value for the 1-byte selector field of the MPS

ATM address.

You can determine the user suffix values for MPSs currently configured on the

router by entering the following command at any BCC prompt:

show mpoa server

Based on the output of this command, assign to each new MPS a selector byte

value that is unique among selector byte values used for any other ATM addresses

configured on the router. For example, if the highest user suffix used by any

MPOA servers configured on the router is 0011223344556677 (selector byte

value = 77), you could assign the next available user suffix value,

0011223344556678 (selector byte value = 78).

You can set a unique selector byte value using either the BCC or Site Manager.

Note:

When you initially add a LECS ATM address, you do so by configuring

a separate ATM network prefix and ATM user part. However, when you

modify an existing LECS ATM address, you need only change one parameter

that contains both the ATM network prefix and the ATM user part suffix

portion of the LECS address.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 147 148

Keine Kommentare

Avaya Configuring MPOA Services Bedienungsanleitung Seite 60