Avaya Configuring MPOA Services Bedienungsanleitung PDF herunterladen (Seite 48)

Configuring MPOA and NHRP Services

3-2

305861-A Rev 00

Disabling and Reenabling an MPOA Service

The MPOA service on an ATM interface is normally enabled, which allows

MPOA servers (MPSs) configured on that service to operate normally. If you need

to functionally disable all MPSs configured on a service simultaneously, disable

the underlying MPOA service. You can do this using either the BCC or Site

Manager.

Using the BCC

To disable an MPOA Service, navigate to that service and enter:

state disabled

or:

To reenable an MPOA Service, navigate to that service and enter:

state enabled

For example, on a System 5000 router, the following commands:

• Navigate from root (

stack#) level to the MPOA service on existing interface

atm/5/3/1. (Assume that ATM signalling was enabled earlier with atm/5/3/1.)

• Disable the MPOA service, functionally disabling all MPSs configured on

atm/5/3/1.

• Reenable the same MPOA service, functionally reenabling all MPSs

configured on atm/5/3/1.

stack# atm slot 5 module 3 connector 1

atm/5/3/1# mpoa-service

mpoa-service/5/3/1# state disabled

mpoa-service/5/3/1# state enabled

mpoa-service/5/3/1#

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 147 148

Keine Kommentare

Avaya Configuring MPOA Services Bedienungsanleitung Seite 48