Avaya Configuring Frame Relay Services Bedienungsanleitung PDF herunterladen (Seite 239)

117376-C Rev. 00

Index-5

Services Multiline With window, A-32

signaling

call proceeding processing, 2-13

call setup processing, 2-12, 2-13

connect message processing, 2-13

SVC, 2-11

signaling parameters

editing, 3-50

Signalling Control parameter, A-18

Site, A-1

source routing using RFC 1490, 2-18

starting frame relay, 1-1

Station Type parameter, A-13

SVC Call Block parameter, A-38

SVC Control parameter, A-43

SVC Inactivity Mode parameter, A-39

SVC Inactivity Timer parameter, A-39

SVC Inscreening Disable parameter, A-38

SVC Inscreening Usage parameter, A-38

SVC Local Party Number parameter, A-36

SVC Local Party Number Plan parameter, A-37

SVC Local Party Sub-Address parameter, A-37

SVC Local Party Type of Number parameter, A-37

SVC Support parameter, A-36

SVCs, 2-12

call proceeding message, 2-13

call proceeding processing, 2-13

call setup processing, 2-12, 2-13

categories of management frames, 2-9

committed information rate (CIR), 2-4

configuring on a default service record, 1-7

connect message, 2-13

connect message processing, 2-13

definition of, 2-2, 2-3

disconnect indication state, 2-12

disconnect message, 2-13

disconnect message processing, 2-13

exchange identification (XID) frames, 2-9

frame relay signaling, 2-8

incoming call proceeding state, 2-12

LAPF and signaling, 2-8

LAPF operational states, 2-9

LAPF timeout and retransmission timers, 2-10

N200 retransmission timeout, 2-10

numbered information frames, 2-9

numbered supervisory frames, 2-9

release complete message, 2-14

release complete message processing, 2-14

release message, 2-14

release message processing, 2-14

release request state, 2-12

retransmission timeout, 2-10

retransmission timeouts, 2-10, 2-11

setup message, 2-12, 2-13

signaling, 2-11

T200 retransmission timeout, 2-10

timers, 2-12

unnumbered control frames, 2-9

SVCs, adding, 3-41

SVCs, disabling, 3-43

synchronous line configuration, 2-39

T

T200 retransmission timeout, 2-10

T200, Base Timer parameter, A-15

T203, Idle Timer parameter, A-15

T303, Setup Message Timer parameter, A-19

T305, Disconnect Timer parameter, A-19

T308, Release Timer parameter, A-20

T310, Call Proceding Timer parameter, A-20

T322, Status Enq Retry Timer parameter, A-21

Technical Solutions Centers, xix

Technician Interface, configuring buffers for traffic

shaping, 2-32

TEI-assigned state, 2-9

Throughput parameter, A-29

timer recovery state, 2-9

timers, 2-12

LAPF timeout and retransmission, 2-9, 2-10

N200 retransmission, 2-10

retransmission, 2-10, 2-11

T200 retransmission, 2-10

timeout, 2-10

traffic distribution for multiline, 2-36

traffic shaping, 3-65

1 2 ... 234 235 236 237 238 239 240

Kommentare zu diesen Handbüchern

Keine Kommentare