
Configuring Dial Services
9-10 114062 Rev. B
Customizing PPP and Frame Relay Demand Circuits
After you configure a PPP or Frame Relay demand circuit, Site Manager adds
several buttons (Apply, Schedule, Phone Out, and Delete) to each demand circuit
window. You use these buttons to edit the parameter defaults.
To edit the demand circuit parameters:
1. Begin at the Configuration Manager window.
2. Select Dialup > Demand Circuits.
Site Manager displays the Demand Pools window (refer to Figure
9-1).
3. Click on PPP Circuits or FR Circuits.
Site Manager displays the appropriate demand circuit window (refer to
Figure 9-3 as an example).
4. Select a circuit you want to modify.
5. Enter new values for the parameters, according to Table 9-1 and the
parameter descriptions in Appendix A.
6. Click on Apply to save the changes.
7. Click on Done.
T
able 9-1 lists ways to customize PPP and Frame Relay demand circuits and the
parameters you use to make those changes.
Table 9-1. Customizing Demand Circuits
Task Site Manager Parameter
Location in
Appendix A
Force the circuit to activate or
deactivate
Force Dial
Force Take Down
page A-26
page A-26
Deactivate the circuit based on
inactivity
Inactivity Time page A-27
Retry the connection if it fails Retry Max
Retry Delay
page A-27
page A-28
Change which router initiates a call Connection Mode page A-28
(continued)
Kommentare zu diesen Handbüchern