
Getting Started
114062 Rev. B 1-27
Specifying the Backup Mode
The backup mode determines which router initiates a backup connection. To
specify the backup mode:
1. Scroll down the Primary Circuit Definition window to the Backup Mode
parameter.
2. Select a value for the Backup Mode parameter. Master is the default.
If this router is set to Master, the peer must be set to Slave.
3. Go to the next section, “Specifying the Authentication Protocol
Information.”
Specifying the Authentication Protocol Information
For network security, the master router must identify itself when it calls the
remote router. The authentication protocols, CHAP and PAP, enable the
identification process. CHAP is the default protocol. All lines in a pool must use
the same authentication protocol.
To specify the CHAP information for the local router, do the following:
1. Scroll down the Primary Circuit Definition window to the CHAP
parameters.
2. Enter values for the CHAP Local Name and CHAP Secret parameters.
The CHAP Local Name must be unique, but the CHAP Secret must be the
same on both sides of the connection.
3. Do one of the following:
-- If you have ISDN lines in the pool, go to “C
reating an Outgoing Phone
List” on page 1-36.
-- If you have only Raise DTR lines in the pool, click on Done and go to
“Setting
Up the Caller Resolution Table” on page 1-40.
Site Manager: Backup Mode parameter: page A-56
Site Manager: CHAP Local Name parameter: page A-37
Site Manager: CHAP Secret parameter: page A-38
Kommentare zu diesen Handbüchern