
Configuring Dial Services
10-14 114062 Rev. B
Customizing PPP and Frame Relay Backup Circuits
After you configure a primary circuit, Site Manager adds several buttons to the
Primary Circuit Definition window and the FR Primary Interface Definition
window (Apply, Schedule, Phone Out). Use them to modify the backup circuit.
To edit the backup circuit:
1. Select the desired primary circuit and enter new values for the
parameters, according to the descriptions in Appendix A.
2. Click on Apply to save your changes.
3. Click on Done to return to the Configuration Manager window.
T
able 10-2 lists ways to customize PPP and Frame Relay circuits.
Changing the Authentication Protocol for the Primary Circuit
CHAP is the default authentication protocol. To select PAP, you must specify PAP
for the Local Authentication Protocol parameter. For instructions to set this
parameter, refer to Configuring PPP Services.
Table 10-2. Customizing Backup Circuits
Task Site Manager Parameter
Location in
Appendix A
Change which router initiates a call
(PPP only)
Backup Mode page A-56
Modify PPP authentication information
(PPP only)
CHAP Local Name
CHAP Secret
PAP Local ID
PAP Password
Outbound Authentication
page A-37,
page A-38
page A-39
page A-40
page A-41
Customize the duration of the circuit Maximum Up Time
Max UpTime Termination
UpTime Term. Reset
page A-42
page A-42
page A-43
Specify how long the router waits
before activating a backup circuit
(Frame Relay only)
Primary Down Time page A-59
Enable the use of filters for backup
(Frame Relay only)
Use Backup Interface Filters page A-59
Kommentare zu diesen Handbüchern