
Configuring Dial Services
1-4 114062 Rev. B
If you need to refer to a parameter description, click on Help in the Site Manager
window or refer to Appendix A of this manual.
*. Abbreviations: DOD=dial-on-demand, DB=dial backup, BOD=bandwidth-on-demand
Table 1-2. Setting Up a Default Modem or ISDN Configuration
Task Parameters to Set DOD* DB BOD
1. Create a line pool and assign an ID to the
pool
ISDN interfaces only: Before creating a line
pool, select an ISDN port and configure it for
BRI or PRI service.
Pool ID
Port Application Mode
xxx
2. Add one or more lines to the pool and, for
modem lines, configure the interface. For
ISDN lines, the interface is defined before
adding the line to the pool.
None (accept the default) x x x
3. Designate the ISDN switch type
(ISDN only)
Switch Type x x x
4. Specify a local phone number
(ISDN only)
Directory Number
Service Provider ID (SPID) for
United States and Canada only
xxx
5. Add a demand, backup, or bandwidth circuit Pool ID x x x
6. Specify the leased-line connection type Circuit Type x x
Backup Pool ID x
Bandwidth-on-Demand Pool ID x
7. Specify authentication protocol information
(CHAP is the default protocol.)
CHAP Local Name x x x
CHAP Secret x x x
8. Specify the circuit connection mode Demand Connection Mode x
Backup Mode x
Bandwidth Mode x
9. Add protocols
(This chapter uses IP as an example.)
IP Address
IP Adjacent Host
x
10.Create an outgoing phone list Phone Number
Phone Ext/SubAddr
xxx
11.Set up the caller resolution table Caller Name
CHAP Secret
xxx
Kommentare zu diesen Handbüchern