
Configuring Dial Services
1-12 114062 Rev. B
Configuring PRI Lines
PRI lines are available only on the ASN, BCN, and BLN hardware platforms
using the following link modules:
• Single or Dual Port Multichannel T1 Link Module (BLN and BCN)
• Dual Port Multichannel T1 Net Module (ASN)
• 120-ohm Single Port MCE1-II Net Module (BLN and BCN)
• 120-ohm Single or Dual Port MCE1-II Link Module (ASN)
• QMCT1 Link Module (BLN and BCN)
To configure PRI lines:
1. Begin at the Configuration Manager window (refer to Figure 1-1).
2. Click on an MCT1 or MCE1 connector.
Site Manager displays the Port Application window, which is similar to the
window shown in Figure
1-8.
3. Select PRI for the Port Application Mode and click on OK.
Site Manager displays the Clock Parameters window (Figure
1-9).
Figure 1-9. Clock Parameters Window
Site Manager: Port Application Mode parameter: page A-16
Kommentare zu diesen Handbüchern