Avaya BCM 4.0 Networking Konfigurationsanleitung PDF herunterladen (Seite 167)

100

101

Chapter 10 Configuring lines 167

BCM 4.0 Networking Configuration Guide

Table 41 describes the fields found on the Trunk/Line Data main panel.

Table 41 Trunk/Line Data main panel

Attribute Value Description

Line This list contains all the

possible line numbers for the

system, including target lines.

Configure only those lines that are active on the system. (Click the

Active check box and ensure that the Inactive check box is empty).

Trunk Type Loop, PRI, VoIP, Target There are three main categories of lines:

PSTN-based lines: (analog, T1, PRI, BRI)

Voice over IP (VoIP) trunks, which connect through the LAN or

WAN.

Target lines, which are internal channels that provide direct dial

capability.

Control Set DN <control telephone DN>

Default: 221 (default Start DN)

Enter a telephone DN for a telephone that you want to use to turn

service off or on for other telephones using this line.

The control telephone must have the line assigned, or must be

assigned to the line pool the line is in. Refer to “Line Access - Line

Pool Access tab” in the BCM 4.0 Device Configuration

Guide (N0060600).

Tips: External lines and telephones must be programmed to use one of the Scheduled Services:

Ringing, Restriction, and Routing Services.

For maximum flexibility, Nortel recommends that you create two different control telephones, one

for the lines and one for the telephones.

You can turn on a service manually or automatically for all external lines from an assigned control

telephone. However, you cannot combine schedules. A service can only be active as normal service

or one of the six schedules at any one time. Several schedules can be active at one time, but they

must use different services.

Prime Set DN:

None

Assign a telephone to provide backup answering for calls on the

line. For an Auto Answer line, calls are redirected if the received

number is invalid or the target line is busy, and if the

If busy parameter is set To prime.

Each line can be assigned only one prime telephone.

Doorphone note: Ensure that this DN does not belong to a

doorphone.

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 757 758

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM 4.0 Networking Konfigurationsanleitung Seite 167

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Avaya BCM 4.0 Networking