Avaya BCM 4.0 Networking Konfigurationsanleitung PDF herunterladen (Seite 172)

100

101

172 Chapter 10 Configuring lines

N0060606N0060606

Figure 53 Preferences details panel

Table 43 defines the fields on this panel and indicates the lines.

Table 43 Preferences details fields for lines (Sheet 1 of 3)

Attribute Value Description

Legend: Loop = analog/digital loop; GS = ground start; DID = DID; E&M = E&M; BRI = BRI; DPNSS = DPNSS;

VoIP = VoIP; TL = Target and DASS2. Note: PRI fields are all included under the main panel.

Auto privacy

Loop GS DID E&M BRI VoIP

<check box> Define whether one BCM user can select a line in use at another

telephone to join an existing call. Refer to “Turn Privacy on or off” in the

BCM 4.0 Device Configuration Guide (N0060600) (FEATURE 83).

Full autohold

Loop BRI DPNSS VoIP

<check box> Enables or disables Full autohold.

When enabled, if a caller selects an idle line but does not dial any

digits, that line is automatically placed on hold if you then select

another line.

Full autohold is always in place for T1 E&M trunks because it has no

meaning for incoming-only T1 DID trunks.

The default setting should be changed only if Full autohold is required

for a specific application.

Aux. ringer

Loop GS DID E&M BRI DPNSS VoIP TL

<check box> Turn the auxiliary ringer on or off for all telephones using this line.

When programmed on a line, the auxiliary ringer will ring every time a

call is received.

Note: When programmed only on a telephone, no ring occurs for a transferred call.

An auxiliary ringer can also be programmed in Services to ring for a line placed into a

scheduled Ringing service. Refer to “Configuring scheduled service” in the BCM 4.0 Device

Configuration Guide (N0060600).

ANI Number

DID E&M

<check box> Define whether the telephone number of the caller will be shown for

this line.

For T1 E&M and T1 DID trunks connected to a DTM, this setting only

appears if Signaling is set to WinkStart.

The central office must deliver ANI/DNIS in DTMF mode. No additional

equipment is required.

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 757 758

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM 4.0 Networking Konfigurationsanleitung Seite 172

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Avaya BCM 4.0 Networking