Avaya Configuring ATM Services Bedienungsanleitung PDF herunterladen (Seite 68)

Configuring ATM Services

4-10

Enter the VPI and VCI numbers that you want to use for the PVC. Refer

to the following section for guidelines.

5. Click on OK.

Site Manager returns you to the ATM DXI PVC List window (refer to Figure

4-3). The window displays the default parameter values for this PVC.

6. If you want to change the default conﬁguration of the PVC, go to

“Editing PVC Conﬁguration Parameters,” later in this chapter.

To copy an existing PVC, complete the following steps:

1. From the Conﬁguration Manager window (refer to Figure 4-1), select

Protocols➔ATM DXI➔Interfaces.

The ATM DXI Interface List window opens (refer to Figure 4-2).

2. Click on PVCs.

The ATM DXI PVC List window opens (refer to Figure 4-3).

3. Select the PVC that you want to copy.

4. Click on Copy.

The ATM DXI Virtual Circuit window opens (refer to Figure 4-4).

5. Enter the VPI and VCI numbers that you want to use for the PVC. Refer

to the following section for guidelines.

6. Click on OK.

Site Manager returns you to the ATM DXI PVC List window (refer to

Figure 4-3).

7. If you want to edit the default conﬁguration of the PVC, go to “Editing

PVC Conﬁguration Parameters,” later in this chapter.

Note: If you have just completed the procedure to add a PVC, skip to Step 3.

Caution: When you run PVCs in direct or hybrid access mode, the copy

function copies all of the existing PVC-speciﬁc information to the new PVC.

However, this function does not copy the protocols that you have selected and

conﬁgured for that PVC. You must select and conﬁgure any desired protocols

for the newly copied PVC.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 309 310

Keine Kommentare

Avaya Configuring ATM Services Bedienungsanleitung Seite 68