
Configuring IP Services
3-14 114065 Rev. A
You associate a network with an interface by assigning the network’s unique IP
address to the circuit on which the interface is configured.
You can use Site Manager to assign an IP address and subnet mask to an interface.
When you add IP to an interface, IP is automatically enabled on that interface.
You can use Site Manager to disable IP on the interface.
Site Manager: IP Address parameter: page A-22
Site Manager: Subnet Mask parameter: page A-22
Site Manager: Enable parameter: page A-24
Note: When you reconfigure an interface in dynamic mode, IP restarts on that
interface. Thus, if the interface you reconfigure is the interface that supports
Site Manager’s SNMP connection to the router, restarting IP on that interface
will cause Site Manager to temporarily lose its router connection and to
display a warning message. To verify that the change took effect, display the
IP Global Parameters window and inspect the setting.
If you are configuring IP over an SMDS circuit, be sure to enter the correct
addresses in the MAC Address, SMDS Group Address, and SMDS Arp Req
Address parameter boxes displayed on this screen. These addresses are the
same as those you entered in the Individual Address, Group Address, and ARP
Address parameters of the SMDS Configuration window when you configured
SMDS.
Kommentare zu diesen Handbüchern