Avaya Configuring Dial Services Bedienungsanleitung PDF herunterladen (Seite 128)

Configuring Dial Services

4-50

Changing Lines in a Pool

To remove a dial service from an ISDN line, refer to “Modifying the Logical

Lines Conﬁguration” on page 4-55.

To remove a dial service from a COM line or to add additional lines to a pool:

1. Select Dialup➔Demand, Backup, or Bandwidth-on-Demand Pool ID

from the Conﬁguration Manager window.

Site Manager displays the Pools window (refer to Figure 4-22).

2. Highlight the pool ID of the lines you want to modify. Click on Edit.

The Lines Deﬁnition window (refer to Figure 4-4) appears.

— To remove a dial service from a line, click once on the line. If this is the

only line in the pool, the Site Manager deletes the pool as well.

— To add additional lines, repeat the steps in “Creating Line Pools with

Raise DTR and V.25bis Interfaces” (page 4-3) or “Creating Line Pools

with ISDN Interfaces” (page 4-33).

3. Select File➔Exit.

Site Manager returns you to the Pools window (refer to Figure 4-22).

4. Click on Done in the Pools window when you ﬁnish modifying lines.

Changing the Synchronous Parameters for Line Media Type

or Cable Type (Raise DTR or V.25bis)

To edit the synchronous parameters associated with the line media type and the

cable type parameters, go to the Sync window of the Synchronous Line Details

conﬁguration. To access synchronous line parameters, begin at the Conﬁguration

Manager window and select the Circuits➔Edit Circuits option. From here you can

select the circuit that you wish to edit.

For further instructions on accessing and modifying the synchronous line

parameters, refer to Conﬁguring Line Services or Conﬁguring Customer Access

and Trunks (BNX Software).

Caution: If you make changes to a line that is carrying an active circuit, the

router terminates the circuit.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 257 258

Keine Kommentare

Avaya Configuring Dial Services Bedienungsanleitung Seite 128