Avaya Configuring Dial Services Bedienungsanleitung PDF herunterladen (Seite 87)

Creating Line Pools

4-9

Parameter: Cable Type

Default: RS232

Options: NULL | RS232 | RS422 | V35 | X21

Function: Indicates the physical interface type supported by the attached dial unit.

Instructions: Select the option that corresponds to the interface type supported by the

attached dial unit.

MIB Object ID: 1.3.6.1.4.1.18.3.4.5.1.83

Parameter: Priority

Default: 1

Range: 1 to 50

Function: Prioritizes a group of lines in the same pool. For example, the router uses

a line of priority 1 before it uses a line of priority 2.

For dial backup and bandwidth-on-demand pools, lines can reside across

slots, but when you set this parameter, it affects only lines on the same

slot. In the case of dial backup, if you have two lines in Slot 3 and three

lines in Slot 4, the router sets a priority between the lines in Slot 3, then

sets a priority between the lines in Slot 4. For bandwidth-on-demand, the

router prioritizes lines in the preferred slot, then the reserved, and ﬁnally

the local slot.

Instructions: Assign a number to each line in the pool. The lower the number, the

higher the priority. For pools that combine Raise DTR/V.25bis lines with

ISDN lines, coordinate the priority assignments for this interface with

those you set via the Pool Channel Priority parameter for the ISDN

interface.

MIB Object ID: 1.3.6.1.4.1.18.3.4.5.1.97

Adding Line Pools

To create additional line pools:

1. Repeat the procedures beginning on page 4-4, “Creating Line Pools with

Raise DTR and V.25bis Interfaces.”

2. Click on Done in the Pools window (Figure 4-7) when you ﬁnish adding

pools.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 257 258

Keine Kommentare

Avaya Configuring Dial Services Bedienungsanleitung Seite 87