Avaya Configuring IP Services Bedienungsanleitung PDF herunterladen (Seite 118)

100

101

Configuring IP Services

2-90

To conﬁgure BFE support on an IP interface, begin at the Conﬁguration Manager

window and perform the following procedures:

1. Conﬁgure an X.25 interface.

When you initially conﬁgure packet-level parameters for the X.25 interface,

make certain to

a. Set the Network Address Type parameter to BFE_NETWORK.

b. Set the DDN IP Address parameter to the IP address that is assigned to

your BFE connection.

2. Edit the packet-layer parameters for the X.25 interface so that they

match the settings speciﬁed in Table 2-3.

3. Add network service record(s) to the X.25 interface.

4. Edit the network service record parameters for the X.25 interface so that

they match the settings speciﬁed in Table 2-4.

Remember to set the DDN BFE parameter to Enable.

5. Enable the IP routing protocol on the X.25 interface.

The IP address speciﬁed must match the one speciﬁed in the packet-layer

parameter setting.

6. Edit the IP interface record.

The address resolution must be set to X.25 BFE DDN. Also conﬁgure IP

security options (RIPSO) on the interface. IP security must be enabled and

labels are required on all outbound data.

For instructions on performing Steps 1 through 4, see Conﬁguring X.25 Services.

For instructions on performing Steps 5 and 6, see the section “Conﬁguring the

Revised IP Security Option” on page 2-16.

Note: Generally, the synchronous line parameter settings are the same for

both a DDN X.25 link and a BFE X.25 link. However, if your operating

environment has speciﬁc needs, you may want to edit synchronous line

parameters. See the appropriate protocol manual for instructions.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 465 466

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya Configuring IP Services Bedienungsanleitung Seite 118

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya Configuring IP Services