Avaya BCM 2.0 Programming Betriebsanweisung PDF herunterladen (Seite 114)

114 Configuring Enterprise Edge Services

Enterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01

Link at CO Some exchanges respond to a Link signal (ƒ‡⁄)by

providing an alternative line for making outgoing calls. When you

enable Link at CO, the system applies the restrictions on outgoing

calls to the digits dialed after the Link signal, and the call on the

alternative line is subject to all restrictions. Disabling Link at CO

prevents a Link signal from resetting the Enterprise Edge

restrictions in cases where the host exchange does not provide an

alternative line.

Values: Y or N (Default: N)

Use auxiliary ringer

Allows you to turn the auxiliary ringer on or off. Refer to Use

auxiliary ringer on page 117.

Values: Y or N (Default: N)

Full autohold Enables or disables full autohold. When enabled, if a caller selects

an idle line but does not dial any digits, that line is automatically

placed on hold if you then select another line. Applies to loop start

and VoIP trunks. Full autohold is always in place for T1 E&M

trunks; it has no meaning for incoming-only T1 DID trunks.

The default setting should be changed only if Full autohold is

required for a specific application.

Values: Y or N (Default: N)

Loss package

Allows you to select the appropriate loss/gain and impedance

settings for each line. For more information refer to

Loss

package on page 117.

Values: Short CO, Medium CO, Long CO, Short PBX, Long

PBX (Default: Medium CO)

Signalling Defines the signal type for the line. Applies to T1 E&M or T1

DID trunks. The immediate setting does not appear for T1 E&M

or T1 DID trunks connected to an EE-DTM if the Dial mode is set

to tone.

Make sure that this matches the signal type programmed for the

trunk at the other switch.

Values: WinkStart, Immediate, DelayDial (Default: Winkstart)

ANI Number Defines whether the telephone number of the caller will be

collected for this line. Applies to T1 E&M and T1 DID trunks.

For T1 E&M and T1 DID trunks connected to an EE-DTM, this

setting only appears if Signalling is set to WinkStart.

The central office must deliver ANI/DNIS in DTMF mode. No

additional equipment is required.

Values: Y or N (Default: N)

DNIS Number Defines whether the digits dialed by an external caller on this line

will be collected. Applies to T1 E&M trunks. For T1 E&M trunks

connected to an EE-DTM, this setting only appears if Signalling is

set toWinkStart and Answer mode is set to Manual.

These digits are required for some third-party software

applications.

Values: Y or N (Default: N)

Attribute Description

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 445 446

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM 2.0 Programming Betriebsanweisung Seite 114

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gateways / Controller Avaya BCM 2.0 Programming