Avaya BCM 2.0 Programming Betriebsanweisung PDF herunterladen (Seite 234)

234 Configuring Enterprise Edge Services

Enterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01

Add a Rule to an Interface

3. Under Configuration, click Add Rule.

The Rule Setting dialog box appears.

4. Configure the Rule settings according to the following table:

Note: If you do not configure the public and private masks correctly the

system will be affected. You must specify addresses that exist. For

example, if you configure an outbound rule, the Public IP address and

Public Mask are the translated addresses. These addresses must be

assigned or packets will be sent to a non-existent destination. For

inbound rules, the translated address is the Private Address and Mask.

5. Click Save.

6. When you finish adding rules, configure the Rule Order box in the Rule

Configuration screen for the interface.

Note: Configure the rule order from most specific to most general. For

example, a TCP rule for one port should come before a general rule for

all TCP traffic. IP rules should come last.

7. Press Tab to update the screen.

Attribute Description

Rule Name (R#) Allows you to assign a number to the Rule.

Direction Allows you to choose if the direction of the rule is In, Out or Both. Both only

applies to IP protocols.

Protocol Allows you to choose the protocol for this interface; IP, TCP, UDP,orTCP/

UDP.

Private IP Type Allows you to specify if the IP type is Fixed or Dynamic.

The default is Fixed.

Private IP Allows you to specify the Private IP address. The Rule is invalid without this

IP address.

Private Mask Allows you to specify the mask to use with the Private IP.

Private Port

Range (#-#)

Allows you to specify a single or range of entries (1-65535) or the following;

ALL, FTP, Telnet, SMTP, DNS, Finger, HTTP, H.323, POP3, NNTP,

RPC, SUNNFS, SNMP, SNMP-TRAP, TFTP and Gopher.

Public IP Type Allows you to specify if the IP type is Fixed or Dynamic.

The default is Fixed.

Public IP Allows you to specify the Public IP address. This address should be on the

outside network.

Public Mask Allows you to specify the mask to use with the Public IP.

If you enter 255.255.255.255 then the Public IP is a single address.

If you enter 0.0.0.0 then the Public IP is all possible addresses.

Public Port

Range (#-#)

Allows you to specify a single or range of entries (1-65535) or the following;

ALL, FTP, Telnet, SMTP, DNS, Finger,HTTP,H.323,POP3,NNTP,

RPC, SUNNFS, SNMP, SNMP-TRAP, TFTP and Gopher.

1 2 ... 229 230 231 232 233 234 235 236 237 238 239 ... 445 446

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM 2.0 Programming Betriebsanweisung Seite 234

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gateways / Controller Avaya BCM 2.0 Programming