Avaya BCM 2.0 Programming Betriebsanweisung Seite 198

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 446
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 197
198 Configuring Enterprise Edge Services
Enterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01
LAN settings for DHCPRelayAgent
If you configured the DHCP mode as DHCPRelayAgent (refer to Configuring a
DHCPRelayAgent on page 194), then configure LAN1 scope attributes as follows.
If the mode is DHCPServer refer to LAN settings for DHCPServer on page 194.
1. Choose Services.ClicktheDHCP navigation key to expand the navigation
tree.
2. Click on the LAN1 heading.
Note: If your Enterprise Edge system has multiple LAN interfaces, you can
see multiple DHCP scopes under DHCP. They are named LAN1,
LAN2, etc. This section describes configuring the DHCP scope for
LAN1. Follow the same instructions to configure any of the
parameters under the scope for LAN2.
The window displays the Relay DHCP packets, Hop-count threshold, and
Seconds-since-boot threshold parameters.
Configure the scope-specific settings. Refer to the DHCP LAN Relay Agent
Interface Parameters table below:
3. Press the Tab key to save the settings.
Attribute Description
Relay DHCP
packets
Allows you to enable or disable the relay of DHCP packets on this
interface.
Enterprise Edge automatically disables this function for each interface.
Hop-count
threshold.
Allows you to specify the maximum number of hops. After this number of
hops, DHCP requests are discarded.
The values are 0 to 16. The default value is 4.
Seconds-since-boot
threshold
Allows you to specify the minimum number of seconds since the last boot,
before Enterprise Edge forwards DHCP requests.
The values are 1to 3600. The default value is 4.
Seitenansicht 197
1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 445 446

Kommentare zu diesen Handbüchern

Keine Kommentare