Avaya BCM 2.0 Programming Betriebsanweisung Seite 35

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 446
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 34
P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations Guide
Setting up your Enterprise Edge system
Refer to the following information when setting up your Enterprise Edge system.
Enterprise Edge required parameters on page 35
Setting up an Enterprise Edge IP Address on page 36
Setting up web-based administration on page 37
Logging on to Enterprise Edge on page 37
Logging off Enterprise Edge on page 40
Rebooting the Enterprise Edge server on page 40
Shutting down Enterprise Edge System on page 40
Licensing on page 41
Configuring system settings on page 41
System registration on page 42
Enterprise Edge required parameters
The Enterprise Edge quick start module provides quick access to the parameters
necessary for the Enterprise Edge server to become active online. However, you
must enter a minimum set of parameters within the quick start module. For more
information, see the Enterprise Edge Installation and Maintenance Guide.
Obtain the required parameter values from an Internet Service Provider (ISP) or
corporate network administrator.
Note: Configure all the required parameters during the initial configuration
session after you power on the Enterprise Edge server and connect with
either an RS-232 or an Ethernet port. After you configure the parameters,
reboot the Enterprise Edge server from either the console or Unified
Manager.
Enterprise Edge required parameters are:
Initial IP address and mask for each network interface
Primary (and optional secondary) DNS servers
Default next-hop router
Fractional T1 channel numbers (if you are using fractional TI)
System name
WAN link protocol
Frame Relay DLCI / CIR (if applicable)
3
Seitenansicht 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 445 446

Kommentare zu diesen Handbüchern

Keine Kommentare