Avaya BCM 2.0 Programming Betriebsanweisung Seite 115

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 446
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 114
Configuring Enterprise Edge Services 115
P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations Guide
Trunk type
Trunk/line data varies with the type of trunk module, the configuration, and what
line you select. For example, you can configure the EE-DTM as PRI or T1.
You can program the following trunk types:
Note: The Fixed data channel trunk type is required if you want to use the soft
router feature in Enterprise Edge. You must first install an EE-DTM and
configure it as Module type, T1 (see Module on page 72.) You must then
configure the Trunk type as Fixed data channel. You can now configure
Module 08 as a Data module (see Configuring a data module on page 79).
Voice over IP trunk considerations
For IP functionality with Enterprise Edge VoIP Gateway, the trunk type is VoIP.
Enterprise Edge VoIP Gateway routes voice traffic over private Internet Protocol
(IP) networks to link multiple sites together using an existing corporate data
network. Lines 001 to 014 are reserved for IP functionality. The number of lines
available for use is a function of software key codes and currently eight of the 14
lines are available for IP functionality.
Note: VoIP trunks should not be accessed through Line appearances as the user
will not receive dial tone.
VoIP trunks should be configured to use a discrete line pool (Pool A to O). Do not
mix other trunk types on the same line pool. You can configure your IP trunks to
use the fallback feature.The use of Line pool codes is not recommended as you will
not be able to configure for fallback. The quality of the IP trunk connection is
assessed during initial call setup, and if the quality is outside the configured
threshold, Enterprise Edge will try to find an alternate route to complete the call
(fallback) based on the programming definitions in the routing table. If you do not
configure your network for fallback and the call quality is below threshold, the IP
call will fail. For an example of a network configuration that supports fallback, see
Toll bypass with Enterprise Edge VoIP Gateway on page 351.
Hardware Unit Trunk Types
EE-DTM PRI
T1Loop,T1E&M,T1Ground,T1DID,T1Fixed
DASS2
DPNSS
EE-CTM (North America) Loop
EE-BRIM S/T BRI-S/T
Enable modules
If you disabled any Trunk Modules prior to perform programming, enable
them now, or your system will not function properly. See
Media Bay
Module status on page 279.
Seitenansicht 114
1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 445 446

Kommentare zu diesen Handbüchern

Keine Kommentare