Avaya BCM 2.0 Programming Betriebsanweisung PDF herunterladen (Seite 133)

Configuring Enterprise Edge Services 133

P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations Guide

Use route

3. In the Use route setting, select what route a call using the destination code takes

during normal service and for each of the schedules. You can program the

automatic schedule times under Scheduled Services. The default Normal route

is 000, it has no External # digits, and uses Pool A.

Absorbed length

4. Select the portion of the destination code that is always absorbed by the

system and not used in the dialing sequence. Select the number of digits to be

deleted: 0, 1, 2, 3, 4, 5,6,orAll.

Setting up a route for local calling

An office can have different suppliers for local and long distance telephone service.

By programming a destination code, any call that begins with 9 (the most common

dial out digit) will automatically use lines dedicated to local service.

The first step is to build a route (underCall Routing in Telephony Services).

• Type 001 (or any other available route number).

You can view defined routes or erase a defined route.

• Assuming that the lines for local calling have been placed in Line pool A,

choose it as the line pool.

• Type the dial out digits (if any) that are needed to direct the call once it is

connected to an external line.

The second step of programming is setting up how the route will work with a

destination code. Because users will dial 9 to make an external call, 9 should be the

destination code.

For local calls only, there are no dial out numbers (compare with Settinguparoute

for long distance calling on page 134).

• Type 9 at Destination Code:.

If entering a code other than 9, a valid destination code must be used. See

Destination codes on page 131.

View existing destination codes before entering a new code.

Tips

The digit absorption setting (absorbed length) only applies to a maximum of

two schedules. Setting digit absorption to 0 minimizes the effort involved in

preparing destination codes. With a 0 setting, the actual digits dialed by a caller

are preserved in the dial out sequence. Programming a dial out sequence as

part of the route may or may not be necessary depending on the required

dialout.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 445 446

Keine Kommentare

Avaya BCM 2.0 Programming Betriebsanweisung Seite 133