Avaya BCM 2.0 Programming Betriebsanweisung PDF herunterladen (Seite 77)

Configuring Enterprise Edge Resources 77

P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations Guide

2. Change the mapping that is applied to incoming calls of this service type to

obtain the received digits. In all cases, the received digits are used to find a

target line or to activate Remote Access.

None: No mapping is applied. The last ‘N’ digits of the Called Party Number

are used as received digits. Note that if there is no called party number (may

occur with some FX calls) the call will ring at the incoming trunk’s Prime set.

All: Lets you define the received digits used for all calls with this service

type, regardless of the called party number or service identifier (SID). For this

option, all calls with this service type on this PRI will ring the same target

line.

Map table: Lets you associate different received digits with different calls of

this service type depending on the call party number and/or the service

identifier. Incoming calls that do not match any entry defined in the map table

will ring at the prime set. Depending on the service type and the protocol, you

may be able to map the called party number (By number) and the service

identifier (SID). The following table shows the different options.

Note: This setting is available for T1 trunks configured as T1 E&M. See Trunk/

line data on page 111 for more information about configuring trunk types.

T1 Parameters (North America only)

The T1 Parameters heading appears for card types that have been configured as T1

or PRI. It lets you define a number of settings that are dependent on your T1 service

provider settings.

To program T1 Parameters:

1. Choose Resources, Media Bay Modules, Bus 02-07, Modules on Bus,

Module 1,andT1 Parameters.

Service

Protocol FX 800 I-800 SDS 900

NI-2 SID By number N/A N/A N/A

DMS-100 SID SID or By number N/A N/A N/A

DMS-250 SID SID or By number N/A N/A SID or By number

4ESS N/A Bynumber Bynumber Bynumber Bynumber

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 445 446

Keine Kommentare

Avaya BCM 2.0 Programming Betriebsanweisung Seite 77