Avaya Configuring WAN Line Services Bedienungsanleitung PDF herunterladen (Seite 186)

Configuring WAN Line Services

8-26

117345-B Rev. 00

Running Port Tests

Port tests affect all logical lines associated with a port. To run FT1 port tests:

Table 8-1

describes the BERT test commands you can send on any FT1 port.

Table 8-2 describes the loopback commands you can send on an FT1 port.

Site Manager Procedure

You do this System responds

1. Set the test parameters in the Port Actions

window. See “Setting Port Test

Parameters” earlier in this chapter.

2. Click on

Apply

3. To start a test, click on the appropriate

Send

command.

4. Repeat step 3

for each test you want to

run.

5. Click on

Done

. The FT1 Port Parameters window opens.

Table 8-1. Send Commands for FT1 Port Tests

Send Command Function

Reset BERT Counters Resets all counters to 0

Insert 1 Error Inserts a single (nonrepeating) error into the bit stream

Insert 1 Error/1K Inserts a deliberate error into every thousandth position in the

bit stream

Insert 1 Error/1M Inserts a deliberate error into every millionth position in the bit

stream

Disable Insert Error Stops the insertion of deliberate errors into the bit stream

Note:

FDL loopback command options apply only when the FT1 line type is

configured as ESF for testing. For more information about FDL loopback

codes, see ANSI T1.408 ISDN Primary Rate - Customer Installation Metallic

Interfaces Layer 1 Specification.

1 2 ... 181 182 183 184 185 186 187 188 189 190 191 ... 293 294

Keine Kommentare

Avaya Configuring WAN Line Services Bedienungsanleitung Seite 186