
Customizing Synchronous and Asynchronous Interfaces
114078 Rev. A 5-21
Viewing the Configured WAN Protocol
You can view which WAN protocol is enabled on this synchronous circuit. Do not
change the current value.
Setting Pass-Through Addresses
You can assign a local MAC address to the local interface using the Pass Thru
Local Address parameter. This address becomes the source address of packets that
are bridged to the destination MAC address.
You assign the destination MAC address with the Pass Thru Remote Address
parameter. This address becomes the destination MAC address of packets that are
bridged to the local MAC address.
Always reverse the local and remote MAC addresses at the remote synchronous
pass-through interface.
When assiging addresses, use any unique MAC address of exactly 12 hexadecimal
digits; be sure that the second digit in the address is a zero, for example,
10fffabc5432.
You can set a Pass Thru Local Address for the interface.
You can set a Pass Thru Remote Address for the interface.
Caution: Changing the WAN protocol does not reconfigure the interface, and
could disable it.
Site Manager: WAN Protocol parameter: page A-64
Site Manager: Pass Thru Local Address parameter: page A-63
Site Manager: Pass Thru Remote Address parameter: page A-64
Kommentare zu diesen Handbüchern