
Site Manager Line Services Parameters
114078 Rev. A A-67
Parameter: KG84A Sync Pulse
Path: COM Connector > Edit Line > Edit Sync Parameters
Default: 10 milliseconds (ms)
Options: 2 to 4096 ms
Function: Specifies the length of the pulse that the router transmits to the KG84A device
when it is necessary to initiate KG84A resynchronization.
The router uses the RTS signal of the V.35 interface, which connects to the
KG84A device’s synchronous signal via a special cable, to initiate KG84A
resynchronization. When the router wants to initiate KG84A resynchronization,
it changes the value of the synchronous signal from low to high. This parameter
specifies the number of ms that the synchronous signal retains its high value.
Instructions: Accept the default or select one of the valid options, and be sure to set the RTS
Enable parameter to Enable.
MIB Object ID: 1.3.6.1.4.1.18.3.4.5.1.70
Parameter: Sync Polling
Path: COM Connector > Edit Line > Edit Sync Parameters
Default: Disable
Options: Enable
| Disable
Function: Indicates whether the Data Set Ready (DSR) signal will be monitored. If you set
this parameter to Enable, the synchronous driver will be enabled when the DSR
is detected. When the DSR is no longer detected, the driver will be disabled.
Enable this parameter only if you will be using dialup services.
Instructions: Either accept the default or set this parameter to Enable.
MIB Object ID: 1.3.6.1.4.1.18.3.4.5.1.76
Kommentare zu diesen Handbüchern